Stock bearings are made for stock applications, but today's Imports are stretching the abilities of stock components and demanding much more.
Toga HP Bearings are meeting those demands and extending the life of today's performance Import motors.
*Most Toga HP Series Mains sets are full grooved to maximize oil flow to the rod bearing. Both rods & mains have a high crush for max retention and reduced overlay thickness to prevent fatigue.
*Rod bearings use hardened steel backs for added strength.
*Toga HP bearings should be used wherever high RPM's (above 6000), nitrous, superchargers, turbochargers or any application where above normal HP & RPM's are made.
*All motors benefit from these HP bearings. These bearings will give longer life to any engine by increasing oil to the pins & eliminating oil starvation.
*All bearings are Tri-metal cast copper lead with copper lead lining to withstand engine loads, along with electroplating babbitted overlay providing optimum service. All bearings are stamped with a red HP.
*All bearings are available in Standard, 10 over and 20 over.
*You can mix the main and rod sizes.
*All bearings hand inspected and stamped.
*All bearings weight in each set within .0001 grams.
Bearings come with a 3 year/36,000 mile warranty. (Does not include racing motors. Warranty non-transferable)
Sizes: All bearings available in STD, 10, 20 over. You can mix the mains and rods sizes.
Notes
ALL SALES ON TOGA BEARINGS ARE FINAL. NO REFUNDS / RETURNS ACCEPTED.
Part was exactly as expected, quality was amazing! Fit perfectly and the motor runs like a dream!
10
05/29/2009
Paseo
Toga Bearings they are almost the best bearings in market for 4efe so like always i don't have a problem at all.
Great Product!!!!!!!!!!!!
10
03/22/2008
Integra
10
11/14/2007
Eclipse
this part is all i wanted it took really long for me to get it but it was worthit.
and brandon was the a good sells person
9
11/29/2006
240SX
Bearing quality looked better than Nissan factory parts. Installation was no problem, fitment generally no problem (the main center bearing was a little tight and didn't allow much crank movement - it appears to have worked itself in, however). Pulled apart after about an hour or so of on-track time, and the bearings looked great. Only downside is that Nissan has several different standard sizes, but these bearings have only one. It was not listed which Nissan standard these bearings attempt to match (note that the Nissan standards are all within the min/max clearance specs).
8
06/10/2006
Supra
This part fit perfect, easy too install, and are working perfectly with my Eagle rods in my 7mgte.
10
03/07/2005
Sentra
THE PRODUCT WAS PERFECT YOU GUYS GOT IT TO ME IN TIME AND I'M ENJOYING THE PERFORMANCE THAT IT GIVES ME. A+ IN MY BOOK.
JUSTIN HABERLING
7
02/16/2005
180SX
Don't know yet.. Engine is ready but needs to be installed still...
10
01/24/2005
MR2
i have put these rod bearings into my mr2 and so far, perfect.
8
12/01/2004
Celica
I installed the Toga Rod Bearings, they worked well, I have yet to have an issue, they were a snug fit (as they should be)... The only complaint I have is how LONG they took to get to me...
10
08/12/2004
Civic
This product was very easy to install, its performance is good. There is no real performance gains as to horsepower or torque, but feel more confident spinning the motor up to 10,000RPM. So far it has lasted 3 months with very hard driving habbits and still going strong. You definatly get your moneys worth when buying this product.
(9.2 of 10)