| Rating | Name | Model | Review |
| |
| 9 | Dustin Fisher | Supra | "the gasket is great and is holding up flawlessly. i had to cut off one of the tabs to get the head to fit right but other then that it was perfect." |
| 10 | Brian Geouge | Supra | "I have had this headgasket on my 89 Supra turbo for about 4 months up to 15psi with no problems. There were no rivets that had to be removed, so installation was easy. Great product!" |
| 10 | John Russell | Supra | "So far 17 psi on a SupraSport 525 hp capable BOSS turbo and no leaking. I melted a piston o my last engine at 22 psi with this turbo when my FPR failed and still no blown headgasket with the thiner Titan." |
| 10 | Eddie Schlairet | Supra | "excellent gasket and cheap price. ive always used tms gaskets on my supras and not once had a problem." |
| 9 | Zuliaka Oliveras | Supra | "still holding strong." |
| 8 | Flor Arevalo | Supra | "had to remove one of the rivets, but other than that its working flawlessly... I greatly recomend it ,as long as you have the head machined and posibly be better off machining the block but in my case I didn't and is holding well with ARP studs.... thanks horsepower freaks for all the assistance during my shopping experience." |
| 9 | Jake M | Supra | "Product fit well except two rivits that had to be removed. Its been on for about 3 months and still seals fine." |
| 8 | Luis r Sanchez | Supra |
| 9 | Josh Willhite | Supra | "Great product have over 4000miles on this HG and it's still holding up under severe driving. Had concerns with a rivet being on the head surface but it still sealed fine." |
| 10 | Josh Willhite | Supra | "Installed over four months ago and I must say that I'm impressed that this Metal Head Gasket performed beyond expectations. Fit just as well as an OE head gasket in conjunction with the namebrand head studs it's bulletproof." |
| 8 | Todd Dunham | Supra | "It might be a little early for me to judge this gasket. I've only had it installed for approx. 3 months. So far though it has taken a beating without incident. My only complaint is that I had to remove a rivet on the front passenger side corner IIRC to make it fit right. It was thicker than the gasket and I was concerned that it would reduce the clamping force on the gasket. The other rivets were located such that they would not be clamped between the head and the block so I left them alone." |
