Click to shop ecu tuning       

You searched for 1989 Toyota MR2 Pictures


All Toyota Pictures
 
Click Add My MR2 to have your MR2 featured on our site.
 
 

                       

1991 Toyota MR2 Pictures

   Jaime3107's 1991 Toyota MR2
  • Intake: Apexi
  • Exhaust: 3" Magnaflow Muffler all Mandrel piping, Exhaust Depot Downpipe
1990 Toyota MR2 Pictures

   beagle_senior's 1990 Toyota MR2
  • Dyno: 322
  • Body: SW20 Body - Hot House Green Toms Snorkel Aftermarket Engine Lid
  • Motor: JE Pistons Rings Eagle Rods ACL Bearings Cometic Head Gasket Lightened + Shotpeened Crank Stan...
  • Turbo: TR43 Hypergear Turbo Tuned to 19psi @ 322hp
  • Nitrous: FUEL - Sard 800cc Injectors - Sard Fuel Pressure Reg - Bored 8mm fuel rail with dual fee...
  • Intake: 2.5 inch s/s piping heat tapped from turbo to intercooler 3 inch s/s piping heat tapped from interc...
  • Transmission: 5 Speed Manual Short Shift Kit Brass Shift Cable Bushes
  • Intercooler: Greddy Side Mount
  • Exhaust: Custom 3 inch dump pipe with hi-flow cat from GUN Performance 3 inch cat back ehaust
2001 Toyota MR2 Pictures

   jennifer94300's 2001 Toyota MR2
  • Dyno: 140
 
91   Toyota MR2 Pictures

   matt21103's 91 Toyota MR2
  • Dyno: 245
1991 Toyota MR2 Pictures

   Gavin420's 1991 Toyota MR2
1985 Toyota MR2 Pictures

   George21928's 1985 Toyota MR2
 
1991 Toyota MR2 Pictures

   Torsten3815's 1991 Toyota MR2
  • Dyno: 540, 445 ft-lbs
  • Body: EREBUNI/Provotekk Shogun-Style Widebody-Kit total custom, Carbon-Fiber-Hood,
  • Motor: Tom´s Pistons and crankshaft, Carillo Rods, 850cc Injectors, Walbro Fuel Pump, Modified Cyl.Head
  • Turbo: T66 It´s a T67-Kit Horsepowerfreaks
  • Nitrous: Don´t need it - might need it later...
  • Cam: HKS 272°
  • Intake: Provotekk Open-Intake-System with HKS Megaflow
  • Transmission: TRD-Custom, Toda-Clutch and Flywheel
  • Intercooler: Watercooled Toyota Intercooler modified
  • Exhaust: Provotekk 3" Race-Exhaust-System
92   Toyota MR2 Pictures

   Sergey46587's 92 Toyota MR2
  • Dyno: 704, 495 ft-lbs
  • Body: 93 lip Custom SAINS side vents JDM clear corners
  • Motor: 2.2 Stroker built by Chris K. -5SFE block and crank -3SGTE head Eagle rods ARP rod bolts CP .02...
  • Turbo: Greddy T78 turbo kit T88-34D 18cm Pro-polished compressor housing Greddy Type R External Wastegat...
  • Cam: HKS 272 intake and exhaust cams
  • Transmission: Built tranny Kaaz 1.5 way LSD Phoenix Power 4.5 final drive Tilton Twin Disc clutch with hydrauli...
  • Intercooler: Custom Autolab Garrett 24x12x4.5 TMIC Twin 12" spal fans below the intercooler Tial 50mm Bov
  • Exhaust: SIMS 4" turbo back BurnsStainless Ultralite 4" Muffler
1991 Toyota MR2 Pictures

   Garth40463's 1991 Toyota MR2
  • Dyno: 458, 400 ft-lbs
  • Motor: 1993 3SGTE
  • Turbo: 60-1
  • Nitrous: not yet
  • Cam: HKS 272-272
  • Intake: RMR
  • Transmission: 1993 LSD
 
1991 Toyota MR2 Pictures

   BSepko's 1991 Toyota MR2
  • Dyno: 135, 145 ft-lbs
1991 Toyota MR2 Pictures

   Anthony12663's 1991 Toyota MR2
  • Dyno: 300
  • Motor: 3sgte TURBO ATS ROM TUNE, ATS fuel rail, ATS external wastegate kit/downpipe, supra 540cc injectors...
  • Turbo: Greddy TD06 and entire exhaust ceramic coated.
  • Intake: Apexi
  • Transmission: spec II clutch
  • Intercooler: A2W Spearco 231 type
  • Exhaust: Greddy PE
1991 Toyota MR2 Pictures

   Ian14614's 1991 Toyota MR2
  • Nitrous: Nitrous Express
  • Cam: 264
  • Intake: HKS
  • Intercooler: HKS
  • Exhaust: HKS
 
1993 Toyota MR2 Pictures

   Richard41993's 1993 Toyota MR2
  • 1/4 mile: 12.215@119.36 mph
  • Dyno: 354, 350 ft-lbs
  • Body: Mid Engine 2 door
  • Motor: 3S-GTE
  • Turbo: TD06
  • Cam: Toyota Stock
  • Intake: Custom
  • Intercooler: Greddy
  • Exhaust: KO
1993 Toyota MR2 Pictures

   Steven6719's 1993 Toyota MR2
  • Body: Greddy Front lip, Custom Integra tail lights, Tom's Scoop.
  • Motor: TEC Turbo, Jacob's ICE Pack ignition, Nology Hot Wires, Iridium spark plugs.
  • Turbo: CT-40 TEC Turbo
  • Intake: KN
1990 Toyota MR2 Pictures

   stian33530's 1990 Toyota MR2
  • Dyno: 300, 490 ft-lbs
  • Body: 95 lip
  • Turbo: toyota turbo
  • Intake: home made
  • Intercooler: toyota standar
  • Exhaust: 3" home made