Driveshaft Shop Steel Driveshaft Nissan 240SX S14 non-ABS Manual 95-98
This is a steel 1-piece replacement shaft for the 240SX platform. This shaft is about 5lb less than the factory 2-piece and will give the car a faster throttle response due to the fact the hanger bearing is not moving up and down during acceleration. A less expensive alternative to our aluminum shaft, it has been suggested by a few of the drift cars that we sponsor the steel shaft breaks the tires loose quicker than the aluminum. This steel shaft will give you most of the benefits of the aluminum shaft, without the cost. Please Note: Whether or not the car was equipped with ABS from the factory will change the length of the driveshaft. Be sure to check vehicle before ordering. Comes with 1 year warranty.Please Note:
All aftermarket driveshafts might be slightly larger than factory specs therefore minor clearance might need to be cut or cleared in the driveshaft tunnel. Driveshaft should have a minimum of 1/2" clearance for proper use.
For the past 30 years, Driveshaft Shop has designed many of the driveshafts used in numerous record setting race cars. Vivid Racing carries driveshafts in aluminum, steel, chromoly and now carbon fiber so we can design a solution that fits your needs. Each driveshaft produced is dynamically balanced at over 9000 RPMs to ensure unbeatable reliability. If you need a custom part, give us a call. Vivid Racing can help setup your car with the proper driveshaft or axle from Driveshaft Shop.