The fastest and most cost effective way to wire your racecar or engine conversion with 14 channels capable of controlling injection and ignition duties, the Platinum Sport 2000 can support most modern engines (including 3 rotor engines) with multi-coil or conventional distributor ignition systems as well as aftermarket CDI systems.
It is capable of controlling sequential injection on 4,6,8,10 & 12 cylinder engines and direct fire ignition for engines up to 6 cylinders, or wasted spark ignition on engines up to 8 cylinders.
Suits Square Bosch EV1 injector connectors
Includes PS2000 ECU, Engine Harness and Fuse Block Kit
Full Sequential Injection Pre-wired to connect directly to OEM TFI Module, Includes breakouts for Distributor or Crank Sensor Trigger
11 additional user-definable auxillary inputs
Up to 13 additional user-definable auxillary outputs (Depending on configuration)
Fully user-definable 32 x 32 mapping ( Up to 1024 points)
Wideband "Auto tuning" using user definable target AFR table
Narrow and Wideband closed loop O2 control
Staged injection control for multiple injectors per cylinder (inc rotary)
3D mapped rotary engine ignition split
Soft and hard cut rev limiter
EGT fuel correction, Tuning via TPS with manifold pressure correction
Dual map switching for fuel/ign/boost, Anti-lag (Rally and Launch style)
Rotational idle, Launch Control, VTEC cam timing control
VANOS cam control (intake cam only), Dual intake runner control
Onboard 2.5 BAR MAP sensor (or use with external MAP up to 10 BAR)
Custom sensor calibration (Use your own sensors for temps or fuel/oil pressure etc)
Open or closed loop boost control ( Road speed, RPM or gear based mapping)
Closed loop idle control (Stepper motor and BAC type)
Extra injector control, Thermo-fan control ( Duty cycle or on/off ), Intercooler fan/spray
Alternator control, Engine control relay function, Nitrous switching with fuel / ignition correction
Unless specified otherwise, Haltech warrants its products to be free from defects in material or workmanship for a period of 12 months from the date of purchase.
If the Haltech product is found to be defective as mentioned above, it will be replaced or repaired if returned prepaid along with proof of purchase. Proof of purchase in the form of a copy of the original purchase invoice, receipt or bill of sale which indicates that the product is within the warranty period, must be presented to obtain warranty service.
Replacement or repair of a defective product shall constitute the sole liability of Haltech. To the extent permitted by law, the foregoing is exclusive and in lieu of all other warranties or representations, either expressed or implied, including any implied warranty of merchantability or fitness. In no event shall Haltech, be liable for special or consequential damages.